Hot Air Blower for Mobile Phone Repairing. Also Called SMD Hot Air Gun / SMD Rework Station.



Hot Air Blower for Mobile Phone Repairing is a Very Important and Useful Tool for any Technician. This Machine is likewise known as SMD Hot Air Gun and SMD Rework Station. Some of this Machine also includes Feature for each SMD and BGA Rework and Repairing. Let us speak and understand this Hot SMD Rework Station in some Detail.

What is Hot Air Blower Machine?

Hot Air Blower or SMD Hot Air Gun or SMD Rework Station is a Machine or tool or system that blows warm air for Desoldering (Removing) and Soldering of SMD Electronic Components (Surface Mount Devices or Electronic Components) or IC from the PCB of a Mobile Cell Phone or 
any other PCB.

It is likewise called SMD Rework Station and SMD Hot Air Gun. It has control to Regulate or Control Temperature and Flow of Hot Air. Temperature settings typically variety from 2 hundred to 500 Degree Celsius.

How Does a Hot Air Blower Machine Work?

A hot air blower system is divided into 2 elements – A Station with all the controls to set Temperature and Air Flow and a Hand Piece for Heater or Heating Coil to Release Hot Air. There is a heating element or heater coil (commonly made up of ceramic) inside the handpiece. Cold air flows from the station to the handpiece and while this cold air comes in contact with the Heater or Coil, the air receives hot relying on at the Temperature Setting and Hot Air Blows Out.

How to Use Hot Air Blower for Mobile Phone Repairing for Desoldering and Soldering

Here are the step-via-step instructions to use a Hot Air SMD Rework Station to correctly remove any IC from any Type of PCB and solder:

1.       Set the temperature and air go with the flow at the desired putting. Make sure the temperature is neither too excessive nor too low. A temperature of 400 Degree Celsius is ideal for most soldering and desoldering work. Also, make certain that the air drift putting fits the temperature putting. Proper air and temperature settings are stated within the guide of the machine.

2.       Identify the defective IC and regularly provide hot air to the component. Start by giving warmness from some top and then progressively lower the peak. This will save you the PCB and other electronic components from getting broken due to thermal shock.

3.       When the solder paste is melted, do away with the defective IC the usage of a Tweezers or IC Pick Up Tool.

4.       Clean the tune well. Use desoldering braid if required to cast off all the solder paste from the music.
5.       Dispense clean solder paste at the song and location of the NEW IC.

6.       Give warmness starting from a few heights and gradually reducing the peak of the handpiece of the new air blower.

7.       When the solder is melted, do away with the blower and the NEW IC is soldered.

Tips: Apply suitable excellent NO-Clean Liquid Flux before desoldering and soldering.

Read More:-https://www.dimi.in/